LevelOne GTL-2691 - Manual (Page 1132)

C HAPTER 39 | VLAN Commands
Configuring Port-based Traffic Segmentation
– 1132 –
traffic-segmentation
session
This command creates a traffic-segmentation client session. Use the no
form to remove a client session.
S YNTAX
[no] traffic-segmentation session session-id
session-id – Traffic segmentation session. (Range: 1-4)
D EFAULT S ETTING
None
C OMMAND M ODE
Global Configuration
Command Usage
◆ Use this command to create a new traffic-segmentation client session.
◆ Using the no form of this command will remove any assigned uplink or
downlink ports, restoring these interfaces to normal operating mode.
Example
Console(config)#traffic-segmentation session 1
Console(config)#
traffic-segmentation
uplink/downlink
This command configures the uplink and down-link ports for a segmented
group of ports. Use the no form to remove a port from the segmented
group.
S YNTAX
[no] traffic-segmentation [session session-id] {uplink interface-list
[downlink interface-list] | downlink interface-list}
session-id – Traffic segmentation session. (Range: 1-4)
uplink – Specifies an uplink interface.
downlink – Specifies a downlink interface.
interface-list – One or more ports. Use a hyphen to indicate a
consecutive list of ports or a comma between non-consecutive
ports.
ethernet unit/port
unit - Unit identifier. (Range: 1-8)
port - Port number. (Range: 1-26)
port-channel channel-id (Range: 1-32)
D EFAULT S ETTING
Session 1 if not defined
No segmented port groups are defined.