LevelOne GTL-2691 - Manual (Page 505)

C HAPTER 14 | Basic Administration Protocols
Connectivity Fault Management
– 505 –
D ISPLAYING D ETAILS
FOR R EMOTE MEP S
Use the Administration > CFM > Show Information (Show Remote MEP
Details) page to show detailed information for MEPs located on other
devices which have been discovered through continuity check messages, or
statically configured in the MEP database and verified through cross-check
messages.
CLI R EFERENCES
◆ "show ethernet cfm maintenance-points remote detail" on page 1327
P ARAMETERS
These parameters are displayed:
◆ MD Index – Domain index. (Range: 1-65535)
◆ MA Index – MA identifier. (Range: 0-4094)
◆ MEP ID – Maintenance end point identifier. (Range: 1-8191)
◆ MD Name – Maintenance domain name.
◆ MA Name – Maintenance association name.
◆ Level – Authorized maintenance level for this domain.
◆ MAC Address – MAC address of this MEP entry.
◆ Primary VLAN – Service VLAN ID.
◆ Incoming Port – Port to which this remote MEP is attached.
◆ CC Lifetime – Length of time to hold messages about this MEP in the
CCM database.
◆ Age of Last CC Message – Length of time the last CCM message
about this MEP has been in the CCM database.
◆ Frame Loss – Percentage of transmitted frames lost.
◆ CC Packet Statistics – The number of CCM packets received
successfully and those with errors.
◆ Port State – Port states include:
■
Up – The port is functioning normally.
■
Blocked – The port has been blocked by the Spanning Tree Protocol.
■
No port state – Either no CCM has been received, or nor port status
TLV was received in the last CCM.
◆ Interface State – Interface states include:
■
No Status – Either no CCM has been received, or no interface status
TLV was received in the last CCM.
■
Up – The interface is ready to pass packets.