LevelOne GTL-2691 - Manual (Page 869)

C HAPTER 28 | Authentication Commands
RADIUS Client
– 869 –
C OMMAND M ODE
Global Configuration
E XAMPLE
Console(config)#radius-server acct-port 181
Console(config)#
radius-server auth-
port
This command sets the RADIUS server network port. Use the no form to
restore the default.
S YNTAX
radius-server auth-port port-number
no radius-server auth-port
port-number - RADIUS server UDP port used for authentication
messages. (Range: 1-65535)
D EFAULT S ETTING
1812
C OMMAND M ODE
Global Configuration
E XAMPLE
Console(config)#radius-server auth-port 181
Console(config)#
radius-server host This command specifies primary and backup RADIUS servers, and
authentication and accounting parameters that apply to each server. Use
the no form to remove a specified server, or to restore the default values.
S YNTAX
[no] radius-server index host host-ip-address [auth-port acct_port]
[acct-port auth-port] [key key] [retransmit retransmit]
[timeout timeout]
index - Allows you to specify up to five servers. These servers are
queried in sequence until a server responds or the retransmit period
expires.
host-ip-address - IP address of server.
acct_port - RADIUS server UDP port used for accounting messages.
(Range: 1-65535)
auth-port - RADIUS server UDP port used for authentication
messages. (Range: 1-65535)