LevelOne GTL-2691 - Manual (Page 1273)

C HAPTER 42 | Multicast Filtering Commands
MLD (Layer 3)
– 1273 –
MLD (L AYER 3)
This section describes commands used to configure Layer 3 Multicast
Listener Discovery (MLD) on the switch.
ipv6 mld This command enables MLD on a VLAN interface. Use the no form of this
command to disable MLD on the selected interface.
S YNTAX
[no] ipv6 mld
D EFAULT S ETTING
Disabled
C OMMAND M ODE
Interface Configuration (VLAN)
C OMMAND U SAGE
MLD (including query functions) can be enabled for specific VLAN interfaces
at Layer 3 through the ipv6 mld command.
E XAMPLE
Console(config)#interface vlan 1
Console(config-if)#ipv6 mld
Console(config-if)#end
Console#show ipv6 mld interface
VLAN 1 : Up
MLD : Enabled
MLD Version : 2
MLD Proxy : Disabled
MLD Unsolicited Report Interval : 400 sec
Robustness Variable : 2
Table 164: MLD Commands (Layer 3)
Command Function Mode
ipv6 mld Enables MLD for the specified interface IC
ipv6 mld last-member-
query-response-interval
Configures the frequency at which to send query
messages in response to receiving a leave message
IC
ipv6 mld max-resp-
interval
Configures the maximum host response time IC
ipv6 mld query-interval Configures frequency for sending host query messages IC
ipv6 mld robustval Configures the expected packet loss IC
ipv6 mld static-group Statically binds multicast groups to a VLAN interface IC
ipv6 mld version Configures MLD version used on an interface IC
clear ipv6 mld group Deletes entries from the MLD cache PE
show ipv6 mld groups Displays information for MLD groups PE
show ip igmp interface Displays multicast information for an interface PE