LevelOne GTL-2691 - Manual (Page 905)

C HAPTER 28 | Authentication Commands
802.1X Port Authentication
– 905 –
E XAMPLE
Console(config)#interface eth 1/2
Console(config-if)#dot1x re-authentication
Console(config-if)#
R ELATED C OMMANDS
dot1x timeout re-authperiod (905)
dot1x timeout quiet-
period
This command sets the time that a switch port waits after the maximum
request count (see page 902 ) has been exceeded before attempting to
acquire a new client. Use the no form to reset the default.
S YNTAX
dot1x timeout quiet-period seconds
no dot1x timeout quiet-period
seconds - The number of seconds. (Range: 1-65535)
D EFAULT
60 seconds
C OMMAND M ODE
Interface Configuration
E XAMPLE
Console(config)#interface eth 1/2
Console(config-if)#dot1x timeout quiet-period 350
Console(config-if)#
dot1x timeout re-
authperiod
This command sets the time period after which a connected client must be
re-authenticated. Use the no form of this command to reset the default.
S YNTAX
dot1x timeout re-authperiod seconds
no dot1x timeout re-authperiod
seconds - The number of seconds. (Range: 1-65535)
D EFAULT
3600 seconds
C OMMAND M ODE
Interface Configuration