LevelOne GTL-2691 - Manual (Page 276)

C HAPTER 10 | Class of Service
Layer 2 Queue Settings
– 276 –
◆ If the output port is an untagged member of the associated VLAN,
these frames are stripped of all VLAN tags prior to transmission.
P ARAMETERS
These parameters are displayed:
◆ Interface – Displays a list of ports or trunks.
◆ CoS – The priority that is assigned to untagged frames received on the
specified interface. (Range: 0-7; Default: 0)
W EB I NTERFACE
To configure the queue mode:
1. Click Traffic, Priority, Default Priority.
2. Select the interface type to display (Port or Trunk).
3. Modify the default priority for any interface.
4. Click Apply.
Figure 122: Setting the Default Port Priority
S ELECTING THE
Q UEUE M ODE
Use the Traffic > Priority > Queue page to set the queue mode for the
egress queues on any interface. The switch can be set to service the
queues based on a strict rule that requires all traffic in a higher priority
queue to be processed before the lower priority queues are serviced, or
Weighted Round-Robin (WRR) queuing which specifies a scheduling weight
for each queue. It can also be configured to use a combination of strict and
weighted queuing.
CLI R EFERENCES
◆ "queue mode" on page 1157
◆ "show queue mode" on page 1160
C OMMAND U SAGE
◆ Strict priority requires all traffic in a higher priority queue to be
processed before lower priority queues are serviced.