LevelOne GTL-2691 - Manual (Page 1416)

C HAPTER 48 | IP Interface Commands
IPv6 Interface
– 1416 –
◆ IPv6 must be enabled on an interface before the MTU can be set.
E XAMPLE
The following example sets the MTU for VLAN 1 to 1280 bytes:
Console(config)#interface vlan 1
Console(config-if)#ipv6 mtu 1280
Console(config-if)#
R ELATED C OMMANDS
show ipv6 mtu (1418)
jumbo frame (776)
show ipv6 interface This command displays the usability and configured settings for IPv6
interfaces.
S YNTAX
show ipv6 interface [brief [vlan vlan-id [ipv6-prefix/prefix-length]]]
brief - Displays a brief summary of IPv6 operational status and the
addresses configured for each interface.
vlan-id - VLAN ID (Range: 1-4093)
ipv6-prefix - The IPv6 network portion of the address assigned to
the interface. The prefix must be formatted according to RFC 2373
“IPv6 Addressing Architecture,” using 8 colon-separated 16-bit
hexadecimal values. One double colon may be used in the address
to indicate the appropriate number of zeros required to fill the
undefined fields.
prefix-length - A decimal value indicating how many of the
contiguous bits (from the left) of the address comprise the prefix
(i.e., the network portion of the address).
C OMMAND M ODE
Normal Exec, Privileged Exec
E XAMPLE
This example displays all the IPv6 addresses configured for the switch.
Console#show ipv6 interface
VLAN 1 is up
IPv6 is enabled.
Link-local address:
FE80::200:E8FF:FE93:82A0/64
Global unicast address(es):
2001:DB8:2222:7272::72/96, subnet is 2001:DB8:2222:7272::/96
Joined group address(es):
FF02::1:2
FF02::1:FF00:72
FF02::1:FF00:0
FF02::1:FF93:82A0