Ip ospf dead-interval – LevelOne GTL-2691 User Manual
Page 1497
C
HAPTER
49
| IP Routing Commands
Open Shortest Path First (OSPFv2)
– 1497 –
ip ospf dead-interval
This command sets the interval at which hello packets are not seen before
neighbors declare the router down. Use the no form to restore the default
value.
S
YNTAX
ip ospf [ip-address] dead-interval seconds
no ip ospf [ip-address] dead-interval
ip-address - This parameter can be used to indicate a specific IP
address connected to the current interface. If not specified, the
command applies to all networks connected to the current interface.
seconds - The maximum time that neighbor routers can wait for a
hello packet before declaring the transmitting router down. This
interval must be set to the same value for all routers on the
network. (Range: 1-65535)
C
OMMAND
M
ODE
Interface Configuration (VLAN)
D
EFAULT
S
ETTING
40, or four times the interval specified by the
command.
C
OMMAND
U
SAGE
The dead-interval is advertised in the router's hello packets. It must be a
multiple of the hello-interval and be the same for all routers on a specific
network.
E
XAMPLE
Console(config)#interface vlan 1
Console(config-if)#ip ospf dead-interval 50
Console(config-if)#
R
ELATED
C
OMMANDS