LevelOne GTL-2691 - Manual (Page 1275)

C HAPTER 42 | Multicast Filtering Commands
MLD (Layer 3)
– 1275 –
ipv6 mld max-resp-
interval
This command configures the maximum response time advertised in MLD
queries. Use the no form of this command to restore the default setting.
S YNTAX
ipv6 mld max-resp-interval seconds
no ipv6 mld max-resp-interval
seconds - The report delay advertised in MLD queries.
(Range: 0-255 tenths of a second)
D EFAULT S ETTING
100 (10 seconds)
C OMMAND M ODE
Interface Configuration (VLAN)
C OMMAND U SAGE
◆ By varying the Maximum Response Interval, the burstiness of MLD
messages passed on the subnet can be tuned; where larger values
make the traffic less bursty, as host responses are spread out over a
larger interval.
◆ The number of seconds represented by the maximum response interval
must be less than the Query Interval ( page 1275 ).
E XAMPLE
The following shows how to configure the maximum response time to 20
seconds.
Console(config-if)#ipv6 mld max-resp-interval 200
Console(config-if)#
R ELATED C OMMANDS
ipv6 mld query-interval (1275)
ipv6 mld query-
interval
This command configures the frequency at which host query messages are
sent. Use the no form to restore the default.
S YNTAX
ipv6 mld query-interval seconds
no ipv6 mld query-interval
seconds - The frequency at which the switch sends MLD host-query
messages. (Range: 1-255 seconds)
D EFAULT S ETTING
125 seconds