Sending simple mail transfer protocol alerts – LevelOne GTL-2691 User Manual
Page 409
C
HAPTER
14
| Basic Administration Protocols
Configuring Event Logging
– 409 –
Figure 215: Configuring Settings for Remote Logging of Error Messages
S
ENDING
S
IMPLE
M
AIL
T
RANSFER
P
ROTOCOL
A
LERTS
Use the Administration > Log > SMTP page to alert system administrators
of problems by sending SMTP (Simple Mail Transfer Protocol) email
messages when triggered by logging events of a specified level. The
messages are sent to specified SMTP servers on the network and can be
retrieved using POP or IMAP clients.
CLI R
EFERENCES
◆
P
ARAMETERS
These parameters are displayed:
◆
SMTP Status – Enables/disables the SMTP function. (Default: Enabled)
◆
Severity – Sets the syslog severity threshold level (see table on
) used to trigger alert messages. All events at this level or
higher will be sent to the configured email recipients. For example,
using Level 7 will report all events from level 7 to level 0.
(Default: Level 7)
◆
Email Source Address – Sets the email address used for the “From”
field in alert messages. You may use a symbolic email address that
identifies the switch, or the address of an administrator responsible for
the switch.
◆
Email Destination Address – Specifies the email recipients of alert
messages. You can specify up to five recipients.
◆
Server IP Address – Specifies a list of up to three recipient SMTP
servers. The switch attempts to connect to the other listed servers if
the first fails.