LevelOne GTL-2691 - Manual (Page 1370)

C HAPTER 46 | DHCP Commands
DHCP Server
– 1370 –
ip dhcp pool This command configures a DHCP address pool and enter DHCP Pool
Configuration mode. Use the no form to remove the address pool.
S YNTAX
[no] ip dhcp pool name
name - A string or integer. (Range: 1-8 characters)
D EFAULT S ETTING
DHCP address pools are not configured.
C OMMAND M ODE
Global Configuration
U SAGE G UIDELINES
◆ After executing this command, the switch changes to DHCP Pool
Configuration mode, identified by the (config-dhcp)# prompt.
◆ From this mode, first configure address pools for the network interfaces
(using the network command). You can also manually bind an address
to a specific client (with the host command) if required. You can
configure up to 8 network address pools, and up to 32 manually bound
host address pools (i.e., listing one host address per pool). However,
note that any address specified in a host command must fall within the
range of a configured network address pool.
E XAMPLE
Console(config)#ip dhcp pool R&D
Console(config-dhcp)#
R ELATED C OMMANDS
network (1377)
host (1374)
service dhcp This command enables the DHCP server on this switch. Use the no form to
disable the DHCP server.
S YNTAX
[no] service dhcp
D EFAULT S ETTING
Enabled
C OMMAND M ODE
Global Configuration