Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 848)

824 Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
53-1003031-02
Configuring 6VPE
9
PE-1(config-if-e10000-1/2)# ip ospf area 0
PE-1(config-if-e10000-1/2)# exit
5. MP-BGP Configuration
PE-1(config)# router bgp
PE-1(config-bgp)# address-family vpnv6 unicast
PE-1(config-bgp-vpnv6u)# neighbor 20.0.0.1 remote-as 100
PE-1(config-bgp-vpnv6u)# neighbor 20.0.0.1 capability orf prefixlist send
PE-1(config-bgp-vpnv6u)# exit
6. MPLS Configuration
PE-1(config)# router mpls
PE-1(config-mpls)# mpls-interface ethernet 1/2
PE-1(config-mpls)# lsp 6vpetunn
PE-1(config-mpls-lsp-6vpetunn)# to 2.2.2.2
PE-1(config-mpls-lsp-6vpetunn)# enable
PE-1(config-mpls-lsp-6vpetunn)# exit
P- Configuration
1. OSPF Configuration
P(config)# router ospf
P(config-ospf-router)# area 0
P(config-ospf-router)# exit
2. IPv4 address Configuration
PE-1(config)# interface ethernet 1/2
PE-1(config-if-e10000-1/2)# enable
PE-1(config-if-e10000-1/2)# ip address 10.10.10.1/24
PE-1(config-if-e10000-1/2)# ip ospf area 0
PE-1(config-if-e10000-1/2)# exit
P(config)# interface ethernet 1/3
P(config-if-e10000-1/3)# enable
P(config-if-e10000-1/3)# ip address 20.20.20.2/24
P(config-if-e10000-1/3)# ip ospf area 0
P(config-if-e10000-1/3)# exit
3. Loopback address Configuration
P(config)# interface loopback 1
P(config-lbif-1)# ip address 3.3.3.3/32
P(config-lbif-1)# ip ospf area 0
P(config-lbif-1)# exit
4. MPLS Configuration
P(config)# router mpls
P(config-mpls)# mpls-interface ethernet 1/2
P(config-mpls)# mpls-interface ethernet 1/3
P(config-mpls)# exit