Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 410)

386 Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
53-1003031-02
show mpls rsvp neighbor
2
Example
Brocade# show mpls rsvp neighbor
RSVP neighbors learnt: 4
Nbr Address Interface State Last_Change HelloTx/Rx RR/MsgID
d:h:m:s Count Support
10.152.152.15 e1/2 UP 10:2:31:44 8498/8349 Y/Y
10.92.98.9 e1/12 UP 0:6:39:36 3995/3587 N/Y
10.31.31.15 e4/3 DOWN 6:6:39:36 3000/1267 N/Y
10.92.99.9 e3/2 UP 0:0:31:44 2995/0 N/N
Brocade# show mpls rsvp neighbor 10.92.98.9
Nbr Address: 92.92.98.9, Interface: e1/12, State: UP
Last changed time (d:h:m:s): 0:6:39:38, Number of active LSPs to or from this
Nbr: 22
Hello sent: 3995, received: 3587, Hello-interval: 15 sec, Hello-tolerance: 5
No Hello message received since: 5 sec
Time left to send next Hello Req: 10 sec
Remote instance: 0x65c6b2, Local instance: 0x5a4f9f21
Refresh Reduction: Disabled, Message ID: Enabled
Brocade#show mpls rsvp neighbor 10.1.1.1
RSVP neighbor with the provided IP address does not exist
History
Release Command history
Multi-Service NetIron Release 05.6.00 This command was introduced.
Hello-interval
Hello-tolerance Hello-interval - Frequency at which RSVP-TE Hello Request messages are sent
on the interface in seconds
Hello-tolerance - The number of hello periods which may pass without
receiving a complete Hello message before the Hello session times out.
(Detail mode only.)
Hello Tx/Rx Count Number of Hello packets sent to or received from the neighbor.
RR/MsgID Support Indicates if Refresh Reduction and Message ID support are enabled/
supported by the neighbor.
(Y
- Enabled, N - Disabled)
No Hello message received since This field displays how long back (in seconds) was the last RSVP Hello
(Request OR Ack) message was received.
Time left to send next Hello Req This field is valid and displays the time only when the Neighbor supports RSVP
Hellos. Else it will display “-”. (Detail mode only.)
Remote instance Identifier provided by the remote router during Hello messages
(Dest_Instance or Neighbor_Src_Instance). (Detail mode only.)
Local instance Identifier send to the neighbor during Hello messages (Src_Instance).
(Detail mode only.)
Refresh Reduction Indicates if Refresh Reduction is enabled or supported by the neighbor.
(Detail mode only.)
Message ID Indicates if Message ID support is enabled by the neighbor.
(Detail mode only.)
Field name Description