Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 526)

502 Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
53-1003031-02
Displaying VPLS information
3
WARNING: VPLS id 3 Peer IP Address: 10.21.21.21 is placed in VC Bind Failure state
due to low system memory.
WARNING: VPLS id 3 Peer IP Address: 10.11.11.11 is placed in VC Withdraw Failure
state due to low system memory.
Displaying information about a specified VPLS ID or VPLS name
The show mpls vpls id vpls-id command displays detailed information about a specified VPLS ID.
The show mpls vpls name vpls-name command displays detailed information about a VPLS name.
The output of the show mpls vpls id vpls-id command, and the output of the show mpls vpls name
vpls-name command display the same information for a configured VPLS instance. The display
changes that are described below are applicable to both the show mpls vpls id vpls-id command,
and show mpls vpls name vpls-name command.
When the remote peer is in an operational state, the total VC labels allocated field no longer
displays in the output of the show mpls vpls id vpls-id command, as shown in the following
example.
Brocade# show mpls vpls id 3
VPLS name_raw, Id 3, Max mac entries: 8192
Total vlans: 1, Tagged ports: 3 (3 Up), Untagged ports 0 (0 Up)
IFL-ID: 4097
Vlan 300 inner-vlan 500
Tagged: ethe 3/1 ethe 3/11 ethe 3/13
VC-Mode: Raw
Total VPLS peers: 1 (1 Operational)
Peer address: 10.200.200.200, State: Operational, Uptime: 1 hr 10 min
Tnnl in use: tnl1(4)
LDP session: Up, Local VC lbl: 983072, Remote VC lbl: 983072
Local VC MTU: 1500, Remote VC MTU: 1500
LOCAL VC-Type: Ethernet (0x05), Remote VC-Type: Ethernet (0x05)
CPU-Protection: OFF
Local Switching: Enabled
When a VC type mismatch occurs, the output from the show mpls vpls id vpls-id command displays
the Wait for PW Up (VC type mismatched) state. The Wait for VC parameter check (VC type
mismatched) state no longer displays The total VC labels allocated field is also removed from the
output. In the following example, a VC type mismatch has occurred, and the PW is down. The local
VC MTU and the remote VC MTU are not known by VPLS so there is no information to display. The
Local VC lbl field, the Remote VC lbl field, and the Remote VC MTU field display N/A (non
applicable).