Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 603)

Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide 579
53-1003031-02
raw-pass-through-mode
4
raw-pass-through-mode
A new CLI option is added as part of the VLL configuration to support a raw-pass-through mode to
inter-operate between the vendors. Prior to NetIron R05.5.00, there was only one option to
configure VC mode as “raw-mode” and the default configuration is “tagged-mode”. A new option is
added to allow you to select the “raw-pass-through mode”. This behaves like the “tagged-mode”
when an endpoint is configured as a tagged endpoint or a “raw-mode” when an endpoint is
configured as untagged endpoint.
Syntax [no] vll Name/Id raw-pass-through-mode
Command
default
tagged-mode.
Parameters Name
Up to 64 characters.
Id
Range 1 - 4294967294
Modes Interface sub-configuration mode
Example
Brocade(config)#
Brocade(config)# router mpls
Brocade(config-mpls)# soft-preemption cleanup-timer
Brocade(config-mpls)# vll test 1
Brocade(config-mpls)# vll test 1 raw-pass-through-mode
Brocade(config-mpls-vll-test)# vll-peer 10.0.0.1
Brocade(config-mpls-vll-test)# vlan 100
Brocade(config-mpls-vll-test-vlan-100)# tagged ethernet 1/12
Brocade(config-mpls-vll-test-vlan-100)#
History
Release Command history
NetIron R05.5.00 Command introduced.
Related
commands Related command Description
vll Name/Id cos Optional COS selection.
vll Name/Id raw-mode Raw-mode Ethernet type (VC type 5)(Default is the tagged-mode with VC type 4).