Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 105)

Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide 81
53-1003031-02
MPLS CSPF fate-sharing group
1
Syntax: show mpls lsp name lsp_name
The show mpls bypass-lsp name lsp_name command displays detailed information about a
specific bypass LSP name. The output from the show mpls bypass-lsp name lsp_name command is
enhanced to display CSPF fate-sharing group configuration for a bypass LSP path. In the following
example, the add-penalty parameter is enabled under the CSPF group computation mode for the
bypass LSP path as highlighted below.
Brocade# show mpls bypass-lsp name test
LSP test, to 10.100.100.100
From: 10.20.20.20, admin: UP, status: UP, tunnel interface(primary path):
tnl3
Times primary LSP goes up since enabled: 1
Metric: 0, number of installed aliases: 0 Adaptive
Maximum retries: NONE, no. of retries: 0
Pri. path: NONE, up: yes, active: yes
Setup priority: 7, hold priority: 0
Max rate: 0 kbps, mean rate: 0 kbps, max burst: 0 bytes
Constraint-based routing enabled: yes
Path calculated using constraint-based routing: yes
Path calculated using interface constraint: no
Path cspf-group computation-mode: add-penalty
In the following example output, the backup LSP path is UP. The add-penalty parameter is enabled
under the CSPF group computation mode as highlighted below.