Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 287)

Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide 263
53-1003031-02
Displaying the Traffic Engineering database
1
Displaying MPLS configuration information
The show mpls config command displays all of the user-configured MPLS parameters. Using the
show mpls config command, the user can display all of the following global parameters configured
on a Brocade device:
• ldp
• rsvp
• policy
• mpls-interface
• lsp
• path
• mpls vll
• mpls vpls
• vll local
• bypass-lsp
The user can display the MPLS configuration information in any of the following modes brief, detail,
and filters, as described in the sections that follow.
Displaying in the brief mode
In this mode, the information under router mpls policy, RSVP, LDP, MPLS OAM configuration (BFD),
dynamic bypass global configuration, and SNMP traps are displayed as shown in the following.
Brocade# show mpls config brief
policy
admin-group m2 2
traffic-eng isis level-1
no propagate-ttl
retry-limit 22
rsvp
refresh-interval 40
refresh-multiple 25
ldp
hello-interval 20 hello-timeout 50
hello-interval target 20
ka-interval 18
advertise-labels for 5
session 10.30.30.6 key 1 $!dZ@
targeted-peer 10.44.44.20
tunnel-metric 5000
graceful-restart
graceful-restart reconnect-time 200
graceful-restart recovery-time 100
graceful-restart max-neighbor-reconnect-time 100
graceful-restart max-neighbor-recovery-time 75
bfd
min-tx 100 min-rx 200 multiplier 20
dynamic-bypass