Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 310)

Brocade (config-mpls-bypasslsp-b1)# show mpls bypass-lsp detail
LSP b1, to 10.6.6.6
From: 10.7.7.7, admin: UP, status: UP, tunnel interface(primary path): tnl0
Times primary LSP goes up since enabled: 1
Metric: 0, number of installed aliases: 0 Adaptive
Maximum retries: NONE, no. of retries: 0
Pri. path: NONE, up: yes, active: yes
Setup priority: 7, hold priority: 0
Max rate: 0 kbps, mean rate: 0 kbps, max burst: 0 bytes
Constraint-based routing enabled: yes
Path calculated using constraint-based routing: yes
Path calculated using interface constraint: no
Path cspf-group computation-mode: disabled, cost: 1
Tie breaking: random, hop limit: 0
exclude interface(s): e3/1
OTHER INSTANCE PRIMARY: NEW_INSTANCE admin: DOWN, status: DOWN
Maximum retries: NONE, no. of retries: 0
Pri. path: NONE, up: no, active: no
Setup priority: 7, hold priority: 0
Max rate: 0 kbps, mean rate: 0 kbps, max burst: 0 bytes
Constraint-based routing enabled: yes
Path calculated using constraint-based routing: no
Path calculated using interface constraint: no
Path cspf-group computation-mode: disabled, cost: 0
Tie breaking: random, hop limit: 0
exclude interface(s): e3/2
Active Path attributes:
Tunnel interface: tnl0, outbound interface: e3/2
Tunnel index: 3, Tunnel instance: 1 outbound label: 3
Recorded routes:
Protection codes: P: Local N: Node B: Bandwidth I: InUse
10.2.2.1
Tunnel bandwidth
Maximum BW: 0 kbps
Reservable BW [priority] kbps:
[0] 0 [1] 0 [2] 0 [3] 0
[4] 0 [5] 0 [6] 0 [7] 0
286 Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
53-1003031-02
Transit LSP statistics
1
Syntax: show mpls bypass-lsp detail
The show mpls bypass-lsp wide command allows the user to display the full bypass LSP name in a
single line. Previously, a long LSP name (greater than 12 characters) was text-wrapped in multiple
lines. Now, the full LSP name can be displayed in a single line as shown in the following example.
Brocade(config)# show mpls bypass-lsp wide
Note: LSPs marked with * are taking a Secondary Path
Admin Oper Tunnel Up/Dn Retry Active
Name To State State Intf Times No. Path
by1 10.3.3.3 UP UP tnl1 1 0 --
by2 10.3.3.3 UP UP tnl2 1 0 --
bypasstunnelfromsanfranciscotonewyork 10.3.3.3 UP UP tnl5 1 0
Syntax: show mpls bypass-lsp wide