Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 271)

Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide 247
53-1003031-02
Displaying the Traffic Engineering database
1
Displaying the RSVP version
To display the RSVP version number, as well as the refresh interval and refresh multiple.
Brocade# show mpls rsvp
Resource ReSerVation Protocol, version 1. rfc2205
RSVP protocol = Enabled
R (refresh interval) = 30 seconds
K (refresh multiple) = 3
Syntax: show mpls rsvp
Displaying the status of RSVP interfaces
Use the following command to display the status of RSVP on devices where it is enabled.
Brocade# show mpls rsvp interface
Num of OutSegs Num of
Interface State MD5 RelMsg Bundle SRefresh Act/Inact/Resv Preempts
e3/2 (Trunk8) Up OFF ON ON ON 0/0/0 0
e3/4 (Trunk9) Up OFF ON ON ON 0/0/0 0
e3/6 Up OFF ON ON ON 0/0/0 0
e3/7 (Trunk2) Up OFF ON ON ON 1699/0/1684 1142
e3/8 (Trunk6) Up OFF ON ON ON 167/0/106 0
e4/3 (Trunk3) Up OFF ON ON ON 2526/0/2526 1471
e4/5 (Trunk4) Up OFF ON ON ON 8421/0/8421 2774
e7/1 (Trunk17) Up OFF ON ON ON 8480/0/8421 5479
e7/2 (Trunk19) Up OFF ON ON ON 7489/0/7484 0
e9/3 (Trunk7) Up OFF ON ON ON 178/0/158 0
(output truncated)
Alternatively, for a shorter output, enter the brief version of the command.
Brocade# show mpls rsvp interface brief
Interface State MD5 Auth
e2/1 Up OFF
e2/2 Dn OFF
e4/1 Dn OFF
e4/2 Dn OFF
In the previous example, interfaces e2/1, e2/2, e4/1, and e4/2 have been enabled for RSVP. Of
these interfaces, interface e2/1 can actively send and receive RSVP messages.
Syntax: show mpls rsvp interface [brief]
Table 27 shows the information displayed for each RSVP-enabled interface.
TABLE 27 Output from the show mpls rsvp interface command
Field Description
Interface The RSVP-enabled interface and associated trunk (when applicable).
Status Whether the interface is up or down.