Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 721)

Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide 697
53-1003031-02
Displaying additional BGP or MPLS VPN information
6
Displaying OSPF area information for a VRF
To display OSPF Area Information for a specified VRF, enter the following command at any level of
the CLI.
Brocade# show ip ospf vrf green area
Indx Area Type Cost SPFR ABR ASBR LSA Chksum(Hex)
1 0 normal 0 6 0 0 6 00039ba2
2 1 normal 0 6 0 2 6 0003af4b
Syntax: show ip ospf vrf vrf-name area [area-id] | [ip-address]
The vrf-name parameter specifies the VRF that the user wants to the OSPF area information for.
The area-id parameter shows information for the specified area.
The ip-address parameter displays the entry that corresponds to the IP address the user enters.
Displaying OSPF ABR and ASBR information for a VRF
To display OSPF ABR and ABSR Information for a specified VRF, enter the following command at any
level of the CLI.
Brocade# show ip ospf vrf green border-routers
router ID router type next hop router outgoing interface Area
1 10.2.10.2 ASBR 192.168.201.2 6/3 1
1 10.5.1.3 ASBR 192.168.201.2 6/3 1
Syntax: show ip ospf vrf vrf-name border-routers router-id
The vrf-name parameter specifies the VRF that the user wants to display OSPF ABR and ABSR
information for.
The router-id parameter specifies the display of OSPF ABR and ABSR information for the router with
the specified router ID.