beautypg.com

Generating traps for vrfs – Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) User Manual

Page 662

background image

638

Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide

53-1003031-02

Configuring BGP VPNs on a PE

6

Syntax: traceroute vrf vrf-name | ip-address

The vrf-name is the name of the VRF that the user wants to conduct a traceroute to.

The ip-address is the IP address containing the VRF to which the user wants to conduct a
traceroute.

Generating traps for VRFs

The user can enable and disable SNMP traps for VRFs. VRF traps are enabled by default.

To enable VRF traps after they have been disabled, enter the following command.

Brocade(config)# snmp-server enable traps vrf

Syntax: [no] snmp-server enable traps vrf

Use the [no] form of the command to disable VRF traps.