Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 206)

182 Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
53-1003031-02
Dynamic Bypass LSPs
1
VLLs:
VLLs configured = 2
VLL peers = 2
Peers operational = 2
Local VLLs:
VLLs configured = 0
VLLs operational = 0
Syntax: show mpls summary
Displaying dynamic bypass information
Use the show mpls config to display all dynamic bypass global and interface configurations.
Global or interface dynamic bypass default configurations do not display in show config except for
‘enable’. A user disabled ‘adaptive’ and ‘record’ options display as ‘no adaptive’ and ‘no record’,
respectively.
No dynamic-bypass configurations are shown on interfaces on which a dynamic bypass is enabled
through enable-all-interfaces command. Once the user configures at least one dynamic bypass
command in interface mode, that interface is considered to be a user configured dynamic bypass
interface and the parameters display in the interface configuration.
Brocade# show mpls config
router mpls
policy
. . .
dynamic-bypass
enable
enable-all-interfaces
max-bypasses 150
max-bypasses-per-mp 6
reoptimize-timer 300
mpls-interface e2/3
. . .
dynamic-bypass
enable
max-bypasses-per-mp 5
primary-path dynbypasspath1
traffic-eng mean-rate 1000
reoptimize-timer 100
priority 3 6
hop-limit 4
tie-breaking least-fill
record
cos 4
include-any 4 5
include-all 1 2
exclude-all 3 6
from 10.11.11.11
no adaptive
name-prefix DBypass
Syntax: show mpls config