Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 458)

434 Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
53-1003031-02
MPLS over GRE tunnel
2
gre-tnl200
Admin: Up Oper: Up
Syntax: show mpls interface tunnel tunnel-id
NOTE
Traffic parameters do not apply to GRE.
The user can view the LDP tunnel interface configuration information, such as the hello interval
and timeout, by entering the mpls ldp interface tunnel command. The user can include a tunnel ID
to retrieve specific information.
Syntax: show mpls ldp interface tunnel [tunnel-id]
Brocade# show mpls ldp interface tunnel 200
gre-tnl200, label-space ID: 0
Nbr count: 1
Hello interval: 5 sec, next hello: 0 sec
Hello timeout: 15 sec
Router#show mpls ldp interface
Label-space Nbr Hello Next
Interface ID Count Interval Hello
e1/1 0 1 5 0 sec
gre_tnl200 0 1 5 2 sec
(targeted) 0 0 0 --
The user can view the details of an LDP neighbor by entering the show mpls ldp neighbor
command. To view more detail, enter the detail keyword.
Syntax: show mpls ldp neighbor [detail]
Brocade# show mpls ldp neighbor
Nbr Transport Interface Nbr LDP ID Max Hold Time Left
10.1.1.1 e1/1 10.1.1.1:0 15 12
10.3.3.3 gre-tnl200 10.3.3.3:0 15 12
Router# show mpls ldp neighbor detail
Nbr Transport Addr: 10.1.1.1, Interface: e1/1, Nbr LDP ID: 10.1.1.1:0
MaxHold: 15 sec, Time Left: 10 sec, Up Time: 18 hr 12 min 55 sec
Nbr Transport Addr: 10.3.3.3, Interface: gre-tnl200, Nbr LDP ID: 10.3.3.3:0
MaxHold: 15 sec, Time Left: 10 sec, Up Time: 18 hr 12 min 55 sec
The user can view MPLS LDP path information by entering the show mpls ldp path command.
The show mpls ldp path command has been enhanced to have a filter for path prefix. The path
prefix can be either the IPv4 host address or the IPv4 prefix with subnet mask. Output of the CLI
with the path prefix filter displays a single path entry for a specified path IP prefix.