Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 463)

Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide 439
53-1003031-02
ldp enable
2
ldp enable
When the feature is disabled, the output of the command continues to be as it is in the 5.40
release implementation. In this case, the feature is configured and LDP is down because the
LSR-ID configured is not available on any loopback interface. The output of the command informs
you that the LDP is not initialized and LSR-ID is configured by you. The [no] option removes LDP on
an MPLS interface, including LDP on an MPLS VE interface.
Syntax [no] ldp-enable
Command
default
None.
Parameters None.
Modes Sub-configuration mode, (config-mpls-if-e1000-1/1)
Usage guidelines
Example
Brocade(config-mpls-if-e1000-1/1)#ldp-enable
LDP not initialized.(LSR-id A.B.C.D is not configured on any loopback interface)
History
Release Modification
NetIron R05.5.00 The output of the command informs you that the LDP is not initialized and LSR-ID is configured
by you.
Related
commands
None.