Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 710)

686 Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
53-1003031-02
Displaying BGP or MPLS VRF information
6
Displaying summary route information for a specified VRF
To display summary statistics for all the VPNv4 routes in the device’s BGP route table for a
specified VRF, enter a command such as the following at any level of the CLI.
Brocade# show ip bgp vrf black routes summary
Total number of BGP routes (NLRIs) Installed : 184
Distinct BGP destination networks : 184
Filtered bgp routes for soft reconfig : 0
Routes originated by this router : 4
Routes selected as BEST routes : 184
BEST routes not installed in IP forwarding table : 0
Unreachable routes (no IGP route for NEXTHOP) : 0
IBGP routes selected as best routes : 90
EBGP routes selected as best routes : 90
Syntax: show ip bgp vrf vrf-name routes summary
This display shows the following information.
NLRIs Sent in Update Message The number of NLRIs for new routes the Brocade device has sent to this
neighbor in UPDATE messages:
•
Withdraws – The number of routes the Brocade device has sent to
the neighbor to withdraw.
•
Replacements – The number of routes the Brocade device has sent
to the neighbor to replace routes the neighbor already has.
Peer Out of Memory Count for Statistics for the times the Brocade device has run out of BGP4 memory
for the neighbor during the current BGP4 session:
•
Receiving Update Messages – The number of times UPDATE
messages were discarded because there was no memory for
attribute entries.
•
Accepting Routes (NLRI) – The number of NLRIs discarded because
there was no memory for NLRI entries. This count is not included in
the Receiving Update Messages count.
•
Attributes – The number of times there was no memory for BGP4
attribute entries.
•
Outbound Routes (RIB-out) – The number of times there was no
memory to place a “best” route into the neighbor's route information
base (Adj-RIB-Out) for routes to be advertised.
TABLE 129 BGP VPNv4 summary route information
This field... Displays...
Total number of BGP VPNv4 routes (NLRIs)
Installed The number of BGP VPNv4 routes the Brocade device has installed
in the BGP route table.
Distinct BGP VPNv4 destination networks The number of destination networks the installed routes represent.
The BGP route table can have multiple routes to the same network.
Filtered BGP VPNv4 routes for soft reconfig The number of route updates received from soft-reconfigured
neighbors or peer groups that have been filtered out but retained.
TABLE 128 BGP4 route summary information for a VRF neighbor (Continued)
This field... Displays...