Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 446)

422 Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
53-1003031-02
Displaying LDP information
2
Displaying the LDP packet statistics
The user can display a packet statistics for packet types and packet errors, as shown in the
following.
Brocade# show mpls ldp statistics
Total Since last clear
PacketType Sent Received Sent Received
Link Hello 215 214 215 214
Targeted Hello 138 110 138 110
Init 1 1 1 1
KeepAlive 16 18 16 18
Notification 0 0 0 0
Address 2 0 2 0
AddressWithdraw 0 0 0 0
LabelMapping 0 0 0 0
LabelRequest 0 0 0 0
LabelWithdraw 0 0 0 0
LabelRelease 0 0 0 0
LabelAbortReq 0 0 0 0
Errors Total Since last clear
Rcv pkt bad pdu length 0 0
Rcv pkt bad msg length 0 0
Rcv pkt bad tlv length 0 0
Rcv pkt notify unkn tlv 0 0
Rcv pkt notify unkn addrfam 0 0
Rcv pkt missing tlv 0 0
Rcv pkt incorrect tlv 0 0
Rcv pkt malformed tlv 0 0
Rcv pkt bad traffic parm 0 0
Rcv pkt partial pdu 0 0
Rcv pkt internal error 0 0
TCP send error 0 0
TCP get send pkt error 0 0
TCP memory fail 0 0
Num of TCP socket buffers: 0
Syntax: show mpls ldp statistics
The show mpls ldp statistics command displays the following information
TABLE 64 Output from the show mpls ldp statistics command
This field... Displays...
PacketType The type of LDP packet being counted.
Total The number of the packets of the Type described for the row, sent and received since
the Brocade device came up.
Since Last Clear The number of the packets of the Type described for the row, sent and received since
the last time a clear command was issued.
Errors The type of packet error being counted. These errors are associated with the received
packets only.