Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 813)

Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide 789
53-1003031-02
Displaying VPLS auto-discovery information
8
Displaying information about VPLS auto-discovery and load balancing
The show mpls vpls name command has changed. The total VC labels allocated field is no longer
displayed in the output of the show mpls vpls name command.
To display detailed information about a specified VPLS name, enter the following command.
Brocade# show mpls vpls name c1
VPLS c1, Id 10, Max mac entries: 8192
Total vlans: 0, Tagged ports: 0 (0 Up), Untagged ports 0 (0 Up)
Total VPLS peers: 1 (0 Operational)
auto-discovery enabled, RD 10:10
export RT 10:10
import RT 10:10
Peer address: 10.2.2.2 (auto-discovered), State: Wait for functional local ports
Tnnl in use: (load balance): None
LDP session: Up, Local VC lbl: 983040, Remote VC lbl: N/A
Local VC MTU: 1500, Remote VC MTU: 0
CPU-Protection: OFF
Local Switching: Enabled
Syntax: show mpls vpls name name
AS# The AS number.
State Refer to “State” on page 781.mmd.
Time The time that has passed since the state last changed.
Rt: Accepted The number of routes received from the neighbor that this device
installed in the BGP4 route table. Usually, this number is lower than the
RoutesRcvd number. The difference indicates that this device filtered out
some of the routes received in the UPDATE messages.
Filtered The routes or prefixes that have been filtered out:
•
When soft reconfiguration is enabled, this field shows how many
routes were filtered out (not placed in the BGP4 route table) but
retained in memory.
•
When soft reconfiguration is not enabled, this field shows the
number of BGP4 routes that have been filtered out.
Sent The number of BGP4 routes that the Brocade device has sent to the
neighbor.
ToSend The number of routes the Brocade device has queued to send to this
neighbor.
TABLE 152 Output for the show mpls vpls name command
This field... Displays
VPLS The configured name of the VPLS instance.
Id The VCID of this VPLS instance.
TABLE 151 Output for the show ip bgp l2vpn vpls summary command (Continued)
This field... Displays