Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 250)

226 Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
53-1003031-02
Displaying MPLS and RSVP information
1
.
Brocade# show mpls statistics label 3/1
In-label In-Port(s) In-Packet Count
1024 e3/1 - e3/20 30
1026 e3/1 - e3/20 21
1030 e3/1 - e3/20 100
1032 e3/1 - e3/20 0
1033 e3/1 - e3/20 0
1034 e3/1 - e3/20 12
1036 e3/1 - e3/20 0
To display all MPLS traffic statistics by their MPLS label for a specific port on a Brocade NetIron CES
or Brocade NetIron CER device, enter a command such as the following.
Brocade# show mpls statistics label 1/1
In-label In-Port(s) In-Bytes count
1024 el/1-el/24 315431
Table 15 lists the output displayed for the show mpls statistics label command.
TABLE 15 MPLS statistics label parameters
This field... Displays...
In-label The MPLS label ID.
In-Port (s) The port where the traffic arrives.
In-Packet Count The number of packets meeting the In-label and In-port criteria.
In-Bytes Count The number of bytes meeting the In-label and In-port criteria.
Syntax: show mpls statistics label interface
The interface variable allows the user to limit label statistics displayed to a specified interface.
Displaying MPLS tunnel statistics
To display all of the MPLS traffic statistics by their MPLS tunnel, enter the following command.
Brocade# show mpls statistics tunnel
Tunnel In-Port(s) L3VPN/IPoMPLS Out-Pkt
0 e1/1 - e1/20 0
e2/1 - e2/2 0
e3/1 - e3/2 0
e3/3 - e3/4 0
e4/1 - e4/20 0
1 e1/1 - e1/20 0
e2/1 - e2/2 0
e3/1 - e3/2 0
e3/3 - e3/4 0
e4/1 - e4/20 0
To display all of the MPLS traffic statistics for a specific tunnel, enter a command such as the
following.