Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 465)

Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide 441
53-1003031-02
show mpls ldp
2
show mpls ldp
Displays the inbound FEC-filter configuration.
Syntax show mpls ldp
Parameters None
Command
Modes
User EXEC mode
Privileged EXEC mode
Global configuration mode
Command
Output
The show mpls ldp command displays the following information:
Output field Description
Label Distribution Protocol version The LDP version.
LSR ID The identifier of the device and the loopback interface number the
LDP uses. LDP advertises the address of this loopback interface in
address messages.
Hello interval How often the device sends out LDP link hello and targeted hello
messages.
Hold time value sent in Hellos How long the device waits for its LDP peers to send a hello message.
The hold time is included in the link hello and targeted hello
messages it sends out to its LDP peers.
Hold time multiple The number of KeepAlive messages not received before declaring a
session is down.
KeepAlive interval The number of seconds between successive KeepAlive messages
send for an LDP session.
Keepalive timeout
Inbound FEC filtering prefix-list This gives the name of the prefix-list configured in the LDP for
inbound FEC filtering.
Graceful restart Provides the show GR setting and the status of the forwarding state
hold timer with the remaining time when it is running.
Label Withdrawal Delay How long the device waits before sending a label withdrawal
message for a FEC to a neighbor