Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 243)

Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide 219
53-1003031-02
MPLS LDP-IGP synchronization
1
The value parameter specifies the length of time of the receive label silence timer in milliseconds.
Possible values are from 100 to 60000 milliseconds. The default value is 1000.
Enabling the end-of-lib submode
Configure the end-of-lib submode under LDP to contain all the attributes of the end of lib capability
and notification.
Brocade(conf)# router mpls
Brocade(conf-router-mpls)# ldp
Brocade(conf-router-mpls-ldp)# end-of-lib
Brocade(conf-router-mpls-ldp-eol)#
Diabling the end-of-lib submode
Enabling the end-of-lib submode determines whether the two RFCs 5561 and 5919 are enabled by
the LSR. The user can turn this feature off either by;
• Removing the end-of-lib submode
• Issuing the disable command under the end-of-lib submode.
Brocade(conf)# router mpls
Brocade(conf-router-mpls)# ldp
Brocade(conf-router-mpls-ldp)# end-of-lib
Brocade(conf-router-mpls-ldp-eol)# disable
Syntax: [no] end-of-lib
The [no] form of “disable” enables the feature.
Setting the EOL notification timer
Use the EOL notification timer command under the conf-router-mpls-ldp-eol policy to set the length
of the EOL notification timer. This command is LDP global.
Brocade(conf)# router mpls
Brocade(conf-router-mpls)# ldp
Brocade(conf-router-mpls-ldp)# end-of-lib
Brocade(conf-router-mpls-ldp-eol)# notification-timer
Syntax: EOL notification timer value
The value parameter specifies the length of the EOL notification timer in milliseconds. Possible
values are from 100 to 120000 milliseconds. The default value is 60000.
Setting the EOL transmit label silence timer
Use the tx-label-silence-timer command under conf-router-mpls-ldp-eol policy to sets the length of
the EOL transmit label silence timer. This command is LDP global.
Brocade(conf)# router mpls
Brocade(conf-router-mpls)# ldp
Brocade(conf-router-mpls-ldp)# end-of-lib
Brocade(conf-router-mpls-ldp-eol)# tx-label-silence-timer 2000
Syntax: tx-label-silence-timer value