Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 349)

Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide 325
53-1003031-02
show mpls ldp fec prefix [filtered [in|out]]
2
show mpls ldp fec prefix [filtered [in|out]]
The filtered options on the show mpls ldp fec prefix command now includes lists of both, FECs
filtered due to inbound and outbound FEC filtering configuration. It also has two sub options, “in”
and “out”, to display the FECs filtered due to inbound and outbound FEC filters, respectively. When
one of the upstream mapping for a FEC is filtered, it displays in this list as filtered.
Syntax show mpls ldp fec [prefix [A.B.C.D/filtered/prefix-filter][in/out]]
Parameters prefix
The prefix option displays the total number of Layer FECs specified by the A.B.C.D, filtered, or
prefix-filter variable.
filtered
The filtered option displays only filtered downstream or upstream mappings configuration
information specified by the in or out keyword.
Command
modes
This command operates in all modes.
Usage guidelines When this option is supplied, the display includes a list of upstream and downstream mappings for
the session which are filtered due to the outbound and inbound fec filter configuration.
Command
output
Output field Description
Total number of prefix
FECs: The total number of Layer 3 FECs.
Total number of prefix
FECs installed How many routes the has received from the neighbor during the current BGP4 session:
•
Filtered – Indicates how many of the received routes the device filtered and did not
accept.
•
Filtered or kept – Indicates how many of the received routes the device did not
accept or install because they were denied by filters.
Total number of prefix
FECs filtered (in/out): Number of FECs from this peer which are filtered due to the inbound and outbound FEC
filter configurations.
Destination The IP Prefix associated with the host address or the prefix FEC type.
State The downstream mapping for the FECs not allowed by the configured inbound FEC
filter prefix list. They are retained and their state displayed are suffixed with the
letter (f). This indicates they are retained because of the inbound FEC filtering action.
Out-intf For an ingress FEC, this mentions the output interface to reach to the Next-hop.
The ‘Out-Interface’ field displays the egress interface associated with the FEC entry.
When applicable, the ‘Out-Intf’ field displays a VE interface specified by the vid variable.
Next-hop For an ingress FEC, this mentions the next-hop IP address.
Ingress Displays if the FEC is an ingress FEC.
Egress Displays if the FEC is an egress FEC.
Filtered The FEC is filtered Inbound (In) or Outbound (Out) or is not filtered ( - ).
The show mpls ldp fec prefix filtered command displays the following information.
Example
Brocade# show mpls ldp fec prefix filtered