Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 274)

250 Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
53-1003031-02
Displaying the Traffic Engineering database
1
The detail option displays detailed RSVP session information.
The extensive option displays extensive RSVP session information.
The wide option displays display the full LSP name in a single line.
NOTE
The show mpls rsvp session brief command displays the same information as the show mpls rsvp
session command.
Table 29 describes the output of the show mpls rsvp session command.
TABLE 29 Output from the show mpls rsvp session command
This field... Displays...
Ingress RSVP Information about ingress RSVP sessions.
Transit RSVP Information about transit RSVP sessions.
Egress RSVP Information about egress RSVP sessions.
To Destination (egress LER) of the session.
From Source (ingress LER) of the session; the source address for the LSP that was configured with
the from command.
St State can be UP or DOWN.
Style The RSVP reservation style. Possible values are FF (Fixed Filter), WF (Wildcard Filter), or SE
(Shared Explicit).
Lbl_In The label for inbound packets on this LSP.
Lbl_Out The label applied to outbound packets on this LSP.
Out_If The outbound interface displays the egress interface for a session. When applicable, the
outbound interface displays a VE interface specified by the vid variable.
LSPname The name of the LSP.
The show mpls rsvp session detail command displays when the session is downstream only, as
shown in the following example.