Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 731)

TABLE 135 Output from the show MPLS statistics VRF command
This field... Displays...
VRF Name The name of the VRF MPLS statistics are being collected for.
In-Ports The port where the traffic is received.
Endpt Out-Pkt The number of packets transmitted out of local endpoints.
Tnl Out-Pkt The number of packets transmitted out of lsp tunnels.
Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide 707
53-1003031-02
Displaying additional BGP or MPLS VPN information
6
To clear the MPLS statistics counters.
Brocade# clear mpls statistics
Syntax: clear mpls statistics [label | tunnel | vpls | vrf]
The label parameter clears in-label statistics.
The tunnel parameter clears MPLS tunnel statistics.
The vpls parameter clears VPLS statistics.
The vrf parameter clears vrf statistics.
Displaying IP route information for a VRF
Display IP route information for a specified VRF by entering the following command.
NOTE
When BGP and static routes use an MPLS tunnel as the outgoing interface, the Gateway field
displays DIRECT in the output of the show ip route vrf ip-address command. This is only applicable
when displaying IPv4 routes.
Brocade# show ip route vrf yellow
Total number of IP routes: 2
Type Codes - B:BGP D:Connected S:Static R:RIP O:OSPF; Cost - Dist/Metric
Destination Gateway Port Cost Type
1 10.8.8.8/32 DIRECT loopback 1 0/0 D
2 10.9.9.8/32 DIRECT lsp to1 200/0 B
Syntax: show ip route vrf vrf-name [num] | [ip-addr] | [bgp] | [connected] |[isis] | [ospf] | [rip] |
[static] | [tags]
The vrf-name parameter specifies the VRF that the user wants to display IP route information for.
Displaying RIP information for a VRF
To display RIP Information for a specified VRF, enter the following command at any level of the CLI.