Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 281)

Brocade(config)# show mpls rsvp session dest 10.30.30.30 source 10.10.10.10 tun 1
Codes: DI:Ingress Detour DT:Transit Detour DM:Merged Detour
DE:Egress Detour BI:Ingress Backup BM: Merged Backup BE:Egress Backup
RP:Repaired Session BYI: Bypass Ingress
Total Number of such sessions are: 1
To From St Style Lbl_In Lbl_Out Out_If LSPname
10.30.30.30 10.10.10.10 Up FF 1024 3 e3/1 t1
Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide 257
53-1003031-02
Displaying the Traffic Engineering database
1
Syntax: show mpls rsvp session [destination destination ip [source source ip [tunnel-id id]]]
[in-interface | out-interface | backup | brief |bypass | detail | detour | down | egress |
extensive | ingress | name | ppend | transit | up | wide | p2mp | p2p]
The destination ip variable is the destination IP address.
The source ip variable is the source IP address.
The tunnel-id id variable is numerical value that identifies the tunnel being configured.
The in-interface option limits the display to RSVP sessions coming in through the supplied
interface.
The out-interface option limits the display to RSVP sessions going out through the supplied
interface.
The backup option limits the display to facility backup RSVP sessions.
The brief option limits the display to brief RSVP session information.
The bypass option limits the display to bypass RSVP sessions.
The detail option limits the display to detailed RSVP session information.
The detour option limits the display to detour RSVP sessions.
The down option limits the display to inactive RSVP sessions.
The egress option limits the display to egress RSVP sessions.
The extensive option limits the display to extensive RSVP session information.
The ingress option limits the display to an ingress RSVP sessions.
The name option limits the display RSVP sessions by name.
The ppend option limits the display to RSVP sessions in soft preemption pending state.
The transit option limits the display to transit RSVP sessions.
The up option limits the display to active RSVP sessions.
The wide option displays the long LSP names.
The p2mp option limits the display to point to multipoint sessions.
The p2p option limits the display to point to point sessions.
NOTE
By default, running the show mpls rsvp session command displays only P2P sessions. To view P2MP
sessions, you need to specify show mpls rsvp session p2mp command.