Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 292)

268 Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
53-1003031-02
Transit LSP statistics
1
TABLE 36
Interface module Feature support
Packet count Byte count Rate (kbps)
NI-MLX-1GX20-GC X
NI-XMR-1Gx20-GC X
NI-XMR-10Gx4 X
NI-MLX-10GX4 X
BR-MLX-10GX4-X X
BR-MLX-10Gx4-X-ML X
NI-MLX-10GX8-M X X X
NI-MLX-10GX8-D X X X
BR-MLX-10GX8-X X X X
BR-MLX-10Gx24-DM X X X
BR-MLX-100GX-1 X X X
BR-MLX-100GX-2 X X X
Transit LSP module support
NetIron CES and NetIron CER limitations
LDP LSP statistic collection is not supported; only RSVP LSP transit statistics is supported.
Either Packet or (Byte & Rate) are supported, but not both simultaneously.
The number of counters available to collect the statistics is limited to 2K even though the NetIron
CER and NetIron CES support 4K transit sessions.
Displaying MPLS statistics
The following sections describe the commands used to gather MPLS statistics.
Displaying MPLS label statistics
Use the show mpls statistics label command to display the incoming byte count and rate (in kbps)
on per label basis.
BROCADE# show mpls statistics label
In-label In-Port(s) In-Packet Count In-Byte Count Rate(in kbps)
1024 e2/1 - e2/4 0 0 0
e2/5 - e2/8 0 0 0
1025 e2/1 - e2/4 4929 542190 119
e2/5 - e2/8 0 0 0
2228 e3/1 - e3/8 0 0 0
e3/9 - e3/16 81688115422 13886979621740 7345166
e3/17 - e3/24 0 0 0
1024 e4/1 - e4/24 4929
-- --
To display all MPLS traffic statistics by their MPLS label value, enter a command such as the
following