Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 225)

Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide 201
53-1003031-02
show mpls policy
1
show mpls policy
The configuration which enables liberal mode displays as part of the following command. Note that
by default, this option is disabled and not shown. This is different from the command of
cspf-computation-mode use-bypass-metric, which shows disabled when not enabled.
Syntax show mpls policy
Parameter None.
Command
modes
The command operates under the MPLS policy sub-configuration mode (config-mpls-policy).
Usage guidelines Use to display the current parameter settings configured under the MPLS policy mode.
Command
output
The show mpls policy command displays the following information.
Output field Description
Current MPLS policy settings:
CSPF interface constraint: Directs the router to include the interface address as a constraint when it determines
the shortest path.
CSPF-Group
computation-mode: Specifies the mode that is used when setting up a fate-sharing group.
CSPF computation-mode
use bypass-metric: TE metric of TE link for CSPF computation.
CSPF computation-mode
use bypass-liberal: Liberal mode for CSPF facility backup computation.
CSPF computation-mode: Status of the cspf-computation at the global level.
TTL propagation for MPLS
label: Displays if the TTL propagation for MPLS label is enabled or disabled.
IPVPN: Displays is IPVPN is enabled or disabled.
IP over MPLS: Displays ID IP over MPLS is enabled or disabled.
Inter-AS route filtering: When the user enables inter-as-route filtering, the RTM does not send any inter-AS
routes to MPLS.
Intra-AS iBGP route
filtering: Displays if Intra-AS iBGP route filtering is enabled or disabled.
Example
Brocade# show mpls policy
Current MPLS policy settings:
CSPF interface constraint: disabled
CSPF-Group computation-mode: disabled
CSPF computation-mode use bypass metric: disabled
CSPF computation-mode use bypass liberal: enabled
CSPF computation-mode: use te-metric(by default)
TTL propagation for MPLS label: disabled, IPVPN: disabled, IP over MPLS: enabled
Inter-AS route filtering: enabled, Intra-AS iBGP route filtering: disabled
. . .