beautypg.com

Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) User Manual

Page 497

background image

Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide

473

53-1003031-02

show mpls vpls detail

3

VC-Mode: Raw

Total VPLS peers: 1 (1 Operational)

Peer address: 19.19.19.19, State: Operational, Uptime: 1 min

Tnnls in use (load balance): Candidate count:8 (only 1st 8 is displayed):

tnl3(3)[RSVP] tnl5(3)[RSVP] tnl0(3)[RSVP] tnl7(3)[RSVP] tnl2(3)[RSVP]

tnl4(3)[RSVP] tnl1(3)[RSVP] tnl6(3)[RSVP]

Peer Index:0

Local VC lbl: 983040, Remote VC lbl: 983040

Local VC MTU: 1500, Remote VC MTU: 1500

Local VC-Type: Ethernet(0x05), Remote VC-Type: Ethernet(0x05)

CPU-Protection: OFF

Local Switching: Enabled

Extended Counter: ON

Multicast Snooping: Disabled

CAM2PRAM format is defined below:

TABLE 72

CAM2PRAM Data Format

BITS[31:25]

Bit[24]

Bit [23]

Bits[22:19]

Bits[18;0]

Reserved

ECMP_MASK[4] LOCAL ADDRESS (Used for

DA-MAC Aging)

ECMP_MASK[3:0]

PRAM_INDEX_BASE[18:0]

Brocade# show cam l2vpn 2/19 0000.00b0.00b0

Slot Index MAC

Age

Port

IFL/

VC Label Out Port Remote DA/

PRAM

(Hex)

VLAN

SA

(Hex)

2

9f9df 0000.00b0.00b0 0

2/20

20

N/A

2/15

0

DA

0033e

2

9fb38 0000.00b0.00b0 2

N/A

N/A

983040

Drop

1

SA

003d7

Brocade# dm cam me/15 0x9f9df

(CAM 0x9f9df): data 0072-00140000-00b000b0 mask ffff-ffffffff-ffffffff Valid

(Shadow CAM):

data 0072-00140000-00b000b0 mask ffff-ffffffff-ffffffff

(Access):

device 2, block 7, block index 0x000039df

(Flags):

VALID 1 INUSE(1, 0) RESTORING(0, 0) AGING(1, 0) AGE COUNT(0, 0)

(CAM2PRAM entry 0x13f3be): 0038033e

(CAM2PRAM entry 0x13f3bf [MAC SA or Right IP]): 00380001

For the above case we have a value of 0038033e which indicate an ECMP mask of seven (eight
tunnels).

The ECMP value should always be one less than the actual number of tunnels.

History

Release

Command history

Multi-Service NetIron Release 05.6.00 VPLS Manual LSP assignment for a peer can now accept maximum of eight

LSPs instead of four LSPs.

Related

commands

None