Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) User Manual
Page 693
Brocade# show ip bgp vrf green 10.2.2.0/24
Route Distinguisher: 2:1
Number of BGP Routes matching display condition : 1
Status codes: s suppressed, d damped, h history, * valid, > best, i internal
Origin codes: i - IGP, e - EGP, ? - incomplete
Network Next Hop Metric LocPrf Weight Path
*i 10.2.2.0/24 10.4.4.4 1 100 0 ?
Route is advertised to 2 peers:
10.4.4.4(1) 10.2.2.2(1)
Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
669
53-1003031-02
Displaying BGP or MPLS VRF information
6
Syntax: show ip bgp vrf vrf-name / ip-addr
The address / mask parameter specifies a particular route. When the user also uses the optional
longer-prefixes parameter, then all statistics for routes that match the specified route or have a
longer prefix than the specified route are displayed. For example, when the user specifies
10.157.0.0 longer, then all routes with the prefix 10.157 or that have a longer prefix (such as
10.157.22) are displayed.
The Number of BGP Routes matching display conditions field in this display is described in
below. For information about all other fields in this display, refer to
TABLE 122
VRF route information
This field...
Displays...
Number of BGP Routes matching
display conditions
The number of routes to the network specified as a parameter in the show
ip bgp vpnv4 ip-addr command.
Displaying attribute entries information for a specified VRF
The route-attribute entries table lists the sets of BGP attributes stored in the Brocade device’s
memory. Each set of attributes is unique and can be associated with one or more routes. In fact,
the device typically has fewer route attribute entries than routes. To display the route-attribute
entries table at any level of the CLI.