Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 730)

706 Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
53-1003031-02
Displaying additional BGP or MPLS VPN information
6
To clear the static ARP table in a VRF, enter the following command.
Brocade# clear arp vrf blue
Syntax: clear arp vrf vrf-name
Displaying TCP connections for a VRF
The show ip tcp vrf connections command displays information about each TCP connection on the
VRF, including the local IP address, local port number, remote IP address, remote port number and
the state of the connection. For example.
Brocade# show ip tcp vrf green connections
Local IP address:port <-> Remote IP address:port TCP state (hdl itc cln pdn)
0.0.0.0:179 <-> 0.0.0.0:0 LISTEN (000100bf: 13, 0, 0)
Total 1 TCP connections
Syntax: show ip tcp vrf vrf-name connections
The vrf-name parameter specifies the VRF that the user wants to display TCP connections for.
Displaying MPLS statistics for a VRF
NOTE
Displaying MPLS statistics for a VRF is supported only on the Brocade NetIron XMR and Brocade
MLX series devices.
To display MPLS statistics on a per-interface basis for a specified VRF, enter the following command
at any level of the CLI.
Brocade# show mpls statistics vrf green
VRF Name In-Port(s) Endpt Out-Pkt Tnl Out-Pkt
green e3/1 0 0
e3/2 0 0
e3/3 0 0
e3/4 0 0
e6/1 0 0
e6/2 4367535952 0
e6/3 0 4366414365
e6/4 0 0
Syntax: show mpls statistics vrf vrf-name
The vrf-name parameter specifies the VRF that the user wants to display MPLS statistics for.
For information about the fields in this display, refer the following.