Show mpls ldp fec prefix – Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) User Manual
Page 467
Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
443
53-1003031-02
show mpls ldp fec prefix
2
show mpls ldp fec prefix
Displays prefix FEC information from the LDP FEC database.
Syntax
show mpls ldp fec prefix [{IPaddress|IPaddress/mask-length}]
Parameters
IPaddress
(Optionalepilepsiespecifies the display of L3 FEC information for a specific
FEC IP address.
IPaddress/mask-length
(Optional) Specifies the display of L3 FEC information for a specific IP address
and subnet mask length.
Command
Modes
User EXEC mode
Privileged EXEC mode
Global configuration mode
Command
Output
The show mpls ldp prefix command displays the following information:
Output field
Description
Total number of prefix
FECs
The total number of Layer 3 FECs.
Total number of prefix
FECs with LWD timer
running
The total number of FECs which currently have the label withdrawal delay timer running
Destination
The IP Prefix associated with the host address or the prefix FEC type.
State
State of the FEC which indicates the FEC advertised to any LDP session (state equal to
“current”). When it has no session, it is either called “cur_no_sess” (currently no
session) for local FECs or is marked “retained” for non-local FECs.
Out-intf
For an ingress FEC, this mentions the output interface to reach to the Next-hop. The
Out-Intf field displays the egress interface associated with the FEC entry. When
applicable, the Out-Intf field displays a VE interface specified by the
Next-hop
For an ingress FEC, this mentions the nexthop IP address.
Ingress
Whether the FEC is an ingress FEC.
Egress
Whether the FEC is an egress FEC.
The show mpls ldp prefix command displays the following information for a specific IP address:
Output field
Description
FEC_CB
Memory address of the FEC CB.
idx
A monotonically increasing number assigned to each FEC in the LDP internal FEC tree.
type
FEC type – Prefix FEC is type 2 and Host Address is assigned type 3.
pend_notif
Any notification pending on this FEC.
State
State of the FEC which indicates the FEC advertised to any LDP session (state equal to
“current”). When it has no session, it is either called “cur_no_sess” (currently no
session) for local FECs or is marked “retained” for non-local.
Ingr
Whether the FEC is an ingress FEC.