Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 440)

TABLE 60 Output from the show mpls ldp fec prefix command
This field... Displays...
FEC_CB Memory address of the FEC CB.
idx A monotonically increasing number assigned to each FEC in the LDP internal FEC tree.
type FEC type – Prefix FEC is type 2 and Host Address is assigned type 3.
pend_notif Any notification pending on this FEC.
State State of the FEC which indicates the FEC advertised to any LDP session (state equal to
“current”). When it has no session, it is either called “cur_no_sess” (currently no
session) for local FECs or is marked “retained” for non-local.
Ingr Whether the FEC is an ingress FEC.
Egr Whether the FEC is an egress FEC.
UM Dist Specifies when Upstream Mapping Distribution is complete.
Prefix The IP Prefix associated with the host address or the prefix FEC type.
next_hop For an ingress FEC, this mentions the next- hop IP address. When LDP selects its
outgoing interface as an RSVP tunnel, the next_hop field displays the RSVP tunnel
destination address.
out_if For an ingress FEC, this mentions the output interface to reach to the Next-hop. When
applicable, the Out-Intf field displays a VE interface specified by the variable.
Downstream Mappings Contents of the downstream mapping CB created as a result of the label mapping
received from the downstream LDP peer.
Local LDP ID Local LDP ID of the LDP session to which this downstream mapping CB belongs.
Peer LDP ID Remote LDP ID of the LDP session to which this downstream mapping CB belongs.
Label MPLS label received from the downstream LSR.
State State of label. Either installed or retained.
CB Memory address of the downstream mapping CB.
416 Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
53-1003031-02
Displaying LDP information
2
Displaying LDP FEC summary information
To display FEC summary information, enter the show mpls ldp fec summary command as shown in
the following example.
Brocade# show mpls ldp fec summary
LDP FEC summary:
Total number of prefix FECs: 8
Total number of VC-FEC type 128: 0
Total number of VC-FEC type 129: 0
LDP error statistics:
Total number of route update processing errors: 0
Total number of VC FEC processing errors: 0
Syntax: show mpls ldp fec summary
Table 61 lists the output displayed for the show mpls ldp fec summary command.