Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 681)

Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide 657
53-1003031-02
Displaying BGP or MPLS VPNv4 information
6
Displaying the best routes that were nonetheless not installed in the IP route table
To display the BGP4 routes received from a specific neighbor that are the “best” routes to their
destinations but are not installed in the device’s IP route table, enter a command such as the
following at any level of the CLI.
Brocade# show ip bgp vpnv4 neighbor 192.168.4.211 routes not-installed-best
Each of the displayed routes is a valid path to its destination, but the device received another path
from a different source (such as OSPF, RIP, or a static route) that has a lower administrative
distance. The device always selects the path with the lowest administrative distance to install in the
IP route table.
Syntax: show ip bgp vpnv4 neighbor ip-addr routes not-installed-best
For information about the fields in this display, refer to Table 109 on page 641.
Displaying the routes whose destinations are unreachable
To display BGP4 routes whose destinations are unreachable using any of the BGP4 paths in the
BGP4 route table, enter a command such as the following at any level of the CLI.
Brocade# show ip bgp vpnv4 neighbor 192.168.4.211 routes unreachable
Syntax: show ip bgp vpnv4 neighbor ip-addr routes unreachable
For information about the fields in this display, refer to Table 109 on page 641.
Displaying the Adj-RIB-Out for a VRF neighbor
To display the device’s current BGP4 Routing Information Base (Adj-RIB-Out) for a specific VRF
neighbor and a specific destination network, enter a command such as the following at any level of
the CLI.