Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) User Manual
Page 723
Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
699
53-1003031-02
Displaying additional BGP or MPLS VPN information
6
Displaying OSPF external link state information for a VRF
To display OSPF External Link State Information for a specified VRF, enter the following command at
any level of the CLI.
Brocade# show ip ospf vrf green database external-link-state
Index Aging LS ID Router Netmask Metric Flag
1 491 10.30.1.6 10.5.1.3 ffffffff 00000001 0000
2 1005 10.40.1.30 192.168.201.1 ffffffff 8000000a 0000
3 765 10.60.1.10 192.168.201.1 ffffffff 8000000a 0000
4 1005 10.40.1.9 192.168.201.1 ffffffff 8000000a 0000
5 491 10.30.1.19 10.5.1.3 ffffffff 00000001 0000
6 765 10.60.1.23 192.168.201.1 ffffffff 8000000a 0000
7 1005 10.40.1.22 192.168.201.1 ffffffff 8000000a 0000
8 765 10.60.1.2 192.168.201.1 ffffffff 8000000a 0000
9 1005 10.40.1.1 192.168.201.1 ffffffff 8000000a 0000
10 491 10.30.1.11 10.5.1.3 ffffffff 00000001 0000
11 765 10.60.1.15 192.168.201.1 ffffffff 8000000a 0000
12 1005 10.40.1.14 192.168.201.1 ffffffff 8000000a 0000
13 491 10.30.1.24 10.5.1.3 ffffffff 00000001 0000
14 491 10.30.1.3 10.5.1.3 ffffffff 00000001 0000
Syntax: show ip ospf vrf vrf-name database external-link-state [advertise num] | [extensive] |
[link-state-id ip-addr] | [router-id ip-addr] | [sequence-number num (Hex)] | [status num]
The vrf-name parameter specifies the VRF that the user wants to display OSPF external link state
information for.
The advertise num parameter displays the data in the specified LSA packet. The num parameter
identifies the LSA packet by its position in the Brocade device’s External LSA table. To determine an
LSA packet’s position in the table, enter the show ip ospf vrf vrf-name external-link-state command
to display the table.
The extensive option displays the data in the LSAs in decrypted format.
The link-state-id ip-addr parameter displays the External LSAs for the LSA source specified by
IP-addr.
The router-id ip-addr parameter shows the External LSAs for the specified OSPF router.
The status num option shows status information.
The sequence-number num (Hex) parameter displays the External LSA entries for the specified
hexadecimal LSA sequence number.