Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 538)

Brocade# show mpls vpls detail
VPLS waiting_for_remote_label, Id 400, Max mac entries: 8192
Total vlans: 1, Tagged ports: 1 (1 Up), Untagged ports 0 (0 Up)
IFL-ID: 4100
Vlan 900 inner-vlan 245
Tagged: ethe 7/1
VC-Mode: Tagged
Total VPLS peers: 1 (0 Operational)
Peer address: 10.55.55.55, State: Wait for PW Up (No Label Resource)
Tnnl in use: tnl4(5)
LDP session: Up, Local VC lbl: N/A, Remote VC lbl: N/A
Local VC MTU: 1500, Remote VC MTU: 0,
LOCAL VC-Type: Ethernet Tagged (0x04), Remote VC-Type: UNKNOWN
CPU-Protection: OFF
Local Switching: Enabled
Extended Counter: ON
514 Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
53-1003031-02
MPLS LDP show commands
3
MPLS LDP show commands
When there are issues with the peer VC labels (local or remote), MTU values, or VC type, other than
using the vpls show command as documented in previous sections, the user can also use the mpls
ldp show command to compare the PW VC information.
Using the show mpls ldp vc x command
Here is an example of the show mpls ldp fec vc command where the remote peer is in the
Operational state.
Brocade# show mpls ldp fec vc 1
FEC_CB: 0x34ff85a8, idx: 50, type: 128, pend_notif: None
State: current, Ingr: Yes, Egr: Yes, UM Dist. done: Yes
VC-Id: 1, vc-type: 4, grp-id: 0
Local-mtu: 2000, remote-mtu: 1500, MTU enforcement: disabled
Downstream mappings:
Local LDP ID Peer LDP ID Label State CB
10.21.21.21:0 10.11.11.11:0 983041 Installed 0x34eb2140(-1)
Upstream mappings:
Local LDP ID Peer LDP ID Label CB
10.21.21.21:0 10.11.11.11:0 983040 0x34eb2510(-1)
VPLS MAC age timer configuration overview
This documentation is to describe an enhancement to make the age timer configurable for both
local and remote entries of VPLS MACs in the software cache. This change is added to the NetIron
R05.5.00 software release for the NetIron product line.