Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 719)

Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide 695
53-1003031-02
Displaying additional BGP or MPLS VPN information
6
Displaying the IP route table for a specified VRF
To display the IP routes for a specified VRF, enter the following command at any CLI level.
Brocade# show ip route vrf green
Total number of IP routes: 99
Type Codes - B:BGP D:Connected S:Static R:RIP O:OSPF; Cost - Dist/Metric
Destination Gateway Port Cost Type
1 10.5.1.0/24 192.168.201.2 eth 6/3 110/2 O
2 10.6.1.0/24 10.4.4.4 lsp toR4 200/0 B
3 10.8.1.0/24 10.2.2.2 lsp toR2 200/0 B
4 10.30.1.1/32 192.168.201.2 eth 6/3 110/3 O1
5 10.30.1.2/32 192.168.201.2 eth 6/3 110/3 O1
6 10.30.1.3/32 192.168.201.2 eth 6/3 110/3 O1
7 10.30.1.4/32 192.168.201.2 eth 6/3 110/3 O1
8 10.30.1.5/32 192.168.201.2 eth 6/3 110/3 O1
9 10.30.1.6/32 192.168.201.2 eth 6/3 110/3 O1
10 10.30.1.7/32 192.168.201.2 eth 6/3 110/3 O1
11 10.30.1.8/32 192.168.201.2 eth 6/3 110/3 O1
Syntax: show ip route vrf vrf-name
The vrf-name parameter specifies the VRF that the user wants to display IP routes for.
The following table lists the information displayed by the show ip route vrf command.
TABLE 133 CLI display of IP route table
This field... Displays...
Total number of IP routes The total number of IP routes that are in the specified VRP routing table.
Destination The destination network of the route.
NetMask The network mask of the destination address.
Gateway The next-hop router.
Port The port through which this Brocade device sends packets to reach the route's
destination.
Cost The route's cost.
Type The route type, which can be one of the following:
•
B – The route was learned from BGP.
•
D – The destination is directly connected to this Brocade device.
•
R – The route was learned from RIP.
•
S – The route is a static route.
•
* – The route is a candidate default route.
•
O – The route is an OSPF route. Unless the user uses the ospf option to
display the route table, “O” is used for all OSPF routes. When the user
does use the ospf option, the following type codes are used:
•
O – OSPF intra area route (within the same area).
•
IA – The route is an OSPF inter area route (a route that passes from
one area into another).
•
E1 – The route is an OSPF external type 1 route.
•
E2 – The route is an OSPF external type 2 route.