Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 336)

312 Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
53-1003031-02
show mpls ldp
2
show mpls ldp
The show mpls ldp command displays the inbound FEC-filter configuration. When applying the
prefix-list on LDP filter-FEC before creating it, it displays as “unbound”. The output of show mpls ldp
command is modified to accommodate the out-bound FEC filter configuration. The prefix-list is
displayed as (does not exist) when the given prefix-list is not created in system.
Syntax show mpls ldp [fec [prefix [prefix-filter]]]
Parametersdata
base
fec
The fec option displays the FEC configuration information specified by the prefix, summary, or
vc variable.
prefix
The prefix option displays prefix FEC information.
prefix-filter
The prefix-filter displays filter fec using prefix-list.
Command
modes
This command operates in all modes.
Usage guidelines Use when the outbound filter-fec is set to prefix-list named list-out and the when prefix-list list-out is
already created.
Command
output
The show mpls ldp command displays the following information.
Command output Description
Label Distribution Protocol version The LDP version.
LSR ID The identifier of the device and the loopback interface number the LDP uses.
LDP advertises the address of this loopback interface in address messages.
Hello interval How often the device sends out LDP link hello and targeted hello messages.
Hold time value sent in Hellos How long the device waits for its LDP peers to send a hello message. The
hold time is included in the link hello and targeted hello messages it sends
out to its LDP peers.
KeepAlive interval The number of seconds between successive KeepAlive messages send for
an LDP session.
Hold time multiple The number of KeepAlive messages not received before declaring a session
is down.
KeepAlive timeout The KeepAlive timeout value displays the value used in negotiation during the
LDP session setup.
Inbound FEC filtering prefix-list This gives the name of the prefix-list configured in the LDP for inbound FEC
filtering.