Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 438)

414 Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
53-1003031-02
Displaying LDP information
2
To display detailed information about a specific LDP peer, enter the following command.
Brocade# show mpls ldp peer 10.22.22.22
Peer LDP ID: 10.22.22.22:0, Local LDP ID: 10.24.24.24:0, State: Operational
Session Status UP, Entity Idx: 1, Targeted: No, Target Adj Added: No
Num VLL: 0, Num VPLS: 0
Rcvd VC-FECs:
From 10.5.5.5: Label: 100000, VC Id: 10, Grp_Id: 0, VC Type: 32773, MTU: 5000
From 10.5.5.5: Label: 190448, VC Id: 200, Grp_Id: 0, VC Type: 32772, MTU 5555
For each LDP peer, the command displays the following information:
TABLE 58 Output from the show mpls ldp peer detail command
This field... Displays...
Peer LDP ID The LDP identifier of the peer LSR. The first four octets identify the peer LSR IP
address; the second two octets identify a label space on the LSR. For LSRs
that use per-platform label spaces, the second two octets are always zero.
Local LDP ID This LSRs LDP identifier.
State The LDP session state, as defined in RFC 3036. This can be “Nonexistent”,
“Initialized”, “OpenRec”, “OpenSent”, or “Operational”.
Session Status Whether the session is operationally UP or Down.
Entity Idx This displays the LDP session entity CB index maintained by the LDP session
controller.
Targeted Whether the session was established using Targeted Hello messages (that is,
through extended discovery).
Target Adj Added Whether the targeted adjacency was initiated for this LDP peer.
Num VLL Number of VLL instances using the LDP peer.
Num VPLS Number of VPLS instances using the LDP peer.
Display considerations for LDP FEC information
The show mpls ldp fec command has changed to allows the user to display all Layer 3 FEC
information on the CLI, or specify the FEC type the user wants to display. When displaying the show
mpls ldp fec command, consider the following:
• The prefix option is introduced to the show mpls ldp fec command. The show mpls ldp fec
prefix command displays the total number of Layer 3 FECs. The total number of Layer 3 FECs is
displayed in the Total number of prefix FECs field. For more information on this command, refer
to
“Displaying LDP FEC information” .
• All options that are available under the show mpls ldp fec command have moved to the show
mpls ldp fec prefix command.
• The summary option is introduced to the show mpls ldp fec command. The show mpls ldp fec
summary command displays summarized FEC information. For more information on this
command, refer to
“Displaying LDP FEC summary information” .
• The vc-fec option is renamed to vc option. All options that are under the show mpls ldp vc-fec
command have moved under the show mpls ldp fec vc command. For more information on this
command, refer to
“Displaying the LDP FEC VC information” .