Displaying ospf route information for a vrf, Refer to, Displaying ospf sham links – Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) User Manual
Page 726
Brocade# show ip ospf vrf green redistribute route
10.6.1.0 10.255.255.0 bgp
10.8.1.0 10.255.255.0 bgp
10.40.1.1 10.255.255.255 bgp
10.40.1.2 10.255.255.255 bgp
702
Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
53-1003031-02
Displaying additional BGP or MPLS VPN information
6
In this example, four routes have been redistributed from BGP routes.
Syntax: show ip ospf vrf vrf-name redistribute route
The vrf-name parameter specifies the VRF that the user wants to display routes redistributed into
OSPF for.
Displaying OSPF route information for a VRF
To display the OSPF route information for a specified VRF, enter the following command at any level
of the CLI.
Brocade# show ip ospf vrf green routes
OSPF Area 0x00000001 ASBR Routes 2:
Destination Mask Path_Cost Type2_Cost Path_Type
10.2.10.2 10.255.255.255 1 0 Intra
Adv_Router Link_State Dest_Type State Tag Flags
10.2.10.2 10.2.10.2
Asbr Valid 0 0000
Paths Out_Port Next_Hop Type State
1 6/3 192.168.201.2 OSPF 00 00
In this example, four routes have been redistributed from BGP routes.
Syntax: show ip ospf vrf vrf-name routes [ip-addr]
Syntax: The vrf-name parameter specifies the VRF that the user wants to display OSPF routes for.
The ip-addr parameter specifies a destination IP address. When the user uses this parameter, only
the route entries for that destination are shown.
Displaying OSPF sham links
To display the OSPF sham links information for a VRF, enter the show ip ospf vrf vrf-name
sham-links command at any level of the CLI, as in the following example.
Brocade# show ip ospf vrf CustomerA sham-links
Sham Link in OSPF instance CustomerA to 10.1.1.2 is UP, Established over lsp(LDP)
Area 1 source address 10.1.1.1
Link cost 1 Transmit Delay is 1 sec, State ptpt
Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5
Adjacency State UP, number of interface events 417
Syntax: show ip ospf vrf vrf-name sham-links