Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 534)

510 Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
53-1003031-02
Clearing VPLS traffic statistics
3
To display VPLS traffic statistics for a VPLS instance specified by its VPLS ID, enter the following
command.
Brocade# show mpls statistics vpls 4
VPLS-Name In-Port(s) Endpt-Out-Pkts Tnl-Out-Pkts
--------- ---------- -------------- ------------
test4 e1/1 0 0
e1/2 0 0
e1/3 0 0
e1/4 0 0
test4 e2/1 - e2/10 0 0
e2/11 - e2/20 0 0
e2/21 - e2/30 0 0
e2/31 - e2/40 0 0
test4 e5/1 10828448712 0
e5/2 0 0
e5/3 0 3025869251
e5/4 0 0
Syntax: show mpls statistics vpls [vpls-name | vpls-id]
The vpls-name variable is the configured name for a VPLS instance.
The vpls-id variable is the ID of a VPLS instance.
Table 79 lists the output displayed by the show mpls statistics vpls command.
TABLE 79 Output from the show mpls statistics vpls command
Field Description
VPLS-Name The configured name of the VPLS instance.
In-Port(s) The port where the traffic is received.
Endpt-Out-Pkts The number of packets transmitted out of local endpoints.
Tnl-Out-Pkts The number of packets transmitted out of LSP tunnels.
Clearing VPLS traffic statistics
To clear the entries stored for all VPLS statistics, enter the following command.
Brocade# clear mpls statistics vpls
Syntax: clear mpls statistics vpls [vpls-name | vpls-id]
The vpls-name variable is the configured name for a VPLS instance.
The vpls-id variable is the ID of a VPLS instance.
The support enables simplified interactions between MPLS and VPLS with regard to VPLS peer FSM
transitions. The LDP integration is supported on all platforms.