Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 605)

Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide 581
53-1003031-02
show mpls vll detail
4
Example For tagged endpoint:
Brocade(config)# show mpls vll detail
VLL test, VC-ID 1, VLL-INDEX 0
End-point : tagged vlan 100 e 1/12
End-Point state : Up
MCT state : None
Local VC type : raw-pass-through
Local VC MTU : 1500
Extended Counters: disabled
Counter : disabled
Vll-Peer : 20.0.0.1
State : UP
Remote VC type : tag Remote VC MTU : 1500
Local label : 851968 Remote label : 851968
Local group-id : 0 Remote group-id: 0
Tunnel LSP : LDP (tnl0)
Brocade(config)#
For untagged endpoint:
Brocade(config)# show mpls vll detail
VLL test, VC-ID 1, VLL-INDEX 0
End-point : untagged e 1/12
End-Point state : Up
MCT state : None
Local VC type : raw-pass-through
Local VC MTU : 1500
Extended Counters: disabled
Counter : disabled
Vll-Peer : 20.0.0.1
State : UP
Remote VC type : untag Remote VC MTU : 1500
Local label : 851968 Remote label : 851968
Local group-id : 0 Remote group-id: 0
Tunnel LSP : LDP (tnl0)
Brocade(config)#
History
Related
commands
Release Command history
NetIron R05.5.00 A new option is added to allow you to select “raw-pass-through mode”. This
behaves like “tagged-mode” when the endpoint is configured as tagged endpoint
or “raw-mode” when the endpoint is configured as untagged endpoint.
Related command Description
show mpls vll DECIMAL VLL ID